MAINTENANCE
GUARD REPLACEMENT
See Figure 13.
After extended use, the guard may become worn and need adjustment or replacing. Or, if you drop the angle grinder and damage the guard, it may be necessary to replace it.
To replace the guard:
Unplug the angle grinder. |
Depress spindle lock button and rotate nut with provided |
wrench until spindle locks. |
Using the wrench provided, loosen and remove nut, |
grinding or accessory wheel, and disc flange from spindle |
if necessary. |
NOTE: To prevent damage to the spindle or spindle lock, |
always allow motor to come to a complete stop before |
TO
TIGHTEN
TO
LOOSEN
DISC
FLANGE
WRENCH
FLANGE
NUT
GRINDING WHEEL
engaging spindle lock. |
Unlock the guard clamp lever. |
Remove the guard. |
Place the new guard on the shoulder of the bearing cap, |
aligning the arrow with the slot on the bottom of the angle |
grinder. |
NOTE: If the new guard will not fit, loosen the clamp |
screw until it will slide over the bearing cap. Be sure the |
tabs on the guard are seated in the groove in the bearing |
cap. |
Rotate guard to the correct position as shown in figures |
9 and 10. |
Lock the guard clamp lever. |
Tighten clamp screw securely if needed. |
GUARD | GUARD |
| |
CLAMP |
|
LEVER |
|
ARROW
CLAMP
SCREW
SPINDLE
BEARING CAP
SPINDLE
LOCK BUTTON
Fig. 13
15
