ASSEMBLY
MOUNTING WORK REST
See Figure 6.
nRemove the knob, star washer, and washer from the car- riage bolt on the lower portion of wheel guard.
nUsing the slotted screw, star washer, washer and fasten- ing knob, attach the work rest bracket to the inside of the wheel guard as shown.
NOTE: The grooved work rest mounts on the left side.
NOTE: The work rest bracket's lower slot must be posi- tioned over the pin on the guard.
nWith the remaining fastening knob, install the work rest to the bracket.
NOTE: Adjust the distance between the wheel and the work rest to maintain 1/16 in. or less separation as the diameter of the wheel decreases with use.
WARNING:
Always make sure your bench grinder is securely mounted to a workbench. Failure to do so could result in an accident resulting in possible serious personal injury.
MOUNTING GRINDER TO WORKBENCH
See Figure 7.
If grinder is to be used in a permanent location, it should be fastened securely to a firm supporting surface, such as a workbench with bolts.
nUse 1/4 in. bolts, washers, and nuts (not included). The bolt length should be
nLocate and mark the holes where the grinder is to be mounted.
nDrill four 3/8 in. diameter holes through workbench.
nPlace sander on workbench, aligning holes in base with holes drilled in workbench.
nInsert four 1/4 in. diameter bolts and washers and attach nuts securely.
WORK REST
(RIGHT)
LARGE WASHER
KNOB
WORK REST |
BRACKET |
Fig. 6
CARRIAGE
BOLT PIN
WORK
REST
ASEMBLY
WASHER
KNOB STAR WASHER
Fig. 6
HEX BOLT
WASHER
WASHERS
LOCK
WASHER
HEX NUT
Fig. 7
12
