Unpacking, Tools Needed | Ryobi bts20r guide

UNPACKING

Your Model BTS20R Table Saw is shipped complete in one carton and includes a rip fence, a miter gauge, a blade guard, wheels, and hub caps.

Separate all parts from packing materials and check each one with the illustration and the list of Loose Parts to make sure all items are accounted for before discarding any packing material.

Important: Remove the foam block from between the saw's housing and the motor.

If any parts are missing, do not attempt to assemble the table saw, plug in the power cord, or turn the switch on until the missing parts are obtained and are installed correctly. Call 1-800-525-2579 for assistance if any parts are missing or damaged.

The saw is factory set for accurate cutting. After assem- bling it, check for accuracy. If shipping has influenced the settings, refer to specific procedures explained in the opera- tion and maintenance sections of this manual.

WARNING:

If any parts are missing, do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.

TOOLS NEEDED

1/2 in.

WRENCH

#2 PHILLIPS

SCREWDRIVER

FRAMING SQUARE

Fig. 2

Page 9

Image 9

Ryobi bts20r manual Unpacking, Tools Needed, Wrench #2 Phillips Screwdriver Framing Square

Contents

Save this Manual for Future Reference Operators Manual Product Specifications Table of Contents Rules for Safe Operation Symbol Meaning Read ALL Instructions Blades Coast After Turn OFF Before Making a CUT, be Sure ALL Adjustments are Secure Safety and International Symbols Extension Cords ElectricalElectrical Connection Grounding Instructions Glossary of Terms Unpacking Tools NeededWrench #2 Phillips Screwdriver Framing Square Key Description Qty Loose Parts List Getting to Know Your SAW Features Operating Components Power Switch Speed and Wiring BladesPrecision Ground MICRO-GRAIN Carbide Teeth Blade Rotation Assembling Wheels and HUB Caps AssemblyAssembling Bumpers Wheel Opening the LEG Stand Closing the LEG Stand REMOVING/REPLACING the Throat Plate To Install RIP FenceRIP Fence Front Rail Finger Hole To Install Blade Guard Assembly To Check SAW Blade Installation Replacing the Throat Plate Operation Types of Cuts To Remove the Blade Rotate Blade AdjustingBlade Throatguard Plate Push Bevel Locking Locking Lever Left To CHECK, Replace or Adjust the Blade Guard Assembly Riving Knife Shims HEX NutsInch To Adjust the Blade Depth To Adjust the Blade AngleTo SET the Scale to the Blade See Figures 28 Heeling Paralleling the Blade to the Miter Gage Groove To USE Sliding Table Extension To USE Outfeed SupportTo Make a Cross CUT Outfeed Support Lower SCALE19 Inch Mark Miter Gauge To Make a Straight RIP CUT To Make a Miter CUT To Make a Bevel Cross CUT To Make a Bevel RIP CUTMiter Gauge RIP Fence Bevel Locking Lever To Make NON-THROUGH Cuts To Make a Compound Miter CUTFeatherboard Bevel Locking Lever Pushblock Clamp General Maintenance MaintenanceTo Make Dado Cuts Lubrication To Check the Alignment of the RIP Fence to the Blade To SET Blade AT 0 orStop Bolt Nuts Clamp Screw RIP Fence Blade Locking Handle Screws Problem Possible Cause Solution Trouble ShootingPage Ryobi TECHNOLOGIES, INC Operators Manual 10 in mm Table Saw Model BTS20R