Ryobi BTS21 TOOLS NEEDED

The following tools (not included) are needed for assembly and making adjustments:

TOOLS NEEDED

FEATURES

BLADES

For maximum performance, it is recommended that you

use the 36-tooth, 10 in. carbide-tipped combination blade

provided with your saw. Additional blade styles of the same

high quality are available for specific operations such as

ripping. Your local dealer can provide you with complete

information.

WARNING:

Do not use blades rated less than the speed of this tool.

Failure to heed this warning could result in personal

injury.

Fig. 4

FRAMING SQUARE

PHILLIPS

SCREWDRIVER

FLATHEAD

SCREWDRIVER

COMBINATION

SQUARE

Contents

Main OPERATORS MANUAL 10 in. TABLE SAW TABLE OF CONTENTS INTRODUCTION WARRANTY GENERAL SAFETY RULES READ ALL INSTRUCTIONS Page SPECIFIC SAFETY RULES SYMBOLS SYMBOL NAME DESIGNATION/EXPLANATION SAVE THESE INSTRUCTIONS ELECTRICAL SPEED AND WIRING GROUNDING INSTRUCTIONS EXTENSION CORDS ELECTRICAL CONNECTION GLOSSARY OF TERMS PRODUCT SPECIFICATIONS KNOW YOUR TABLE SAW WARNING: OPERATING COMPONENTS SWITCH ASSEMBLY WARNING: TOOLS NEEDED BLADES LOOSE PARTS UNPACKING MOUNTING HOLES TO INSTALL THE HANDLE ASSEMBLY TO OPEN/CLOSE (SET-UP/TEAR DOWN) THE LEG STAND TO SECURE/LEVEL THE SAW TO STORE THE TABLE SAW ACCESSORIES TO MOVE THE LEG STAND TO REMOVE/REPLACE THE THROAT PLATE TO CHECK SAW BLADE INSTALLATION CAUTION: TO INSTALL MITER FENCE TO INSTALL BLADE GUARD ASSEMBLY TO INSTALL DUST BAG AVOIDING KICKBACK CUTTING AIDS CAUTION: APPLICATIONS BASIC OPERATION OF THE TABLE SAW TYPES OF CUTS WARNING: CUTTING TIPS OPERATION FEATHERBOARD WARNING: HOW TO MAKE A FEATHERBOARD HOW TO MOUNT A FEATHERBOARD CHECKING SLIDING MITER TABLE AND MAKING ADJUSTMENTS TO POSITION THE SLIDING MITER TABLE TO CHECK MITER BASE PARALLELISM TO ADJUST THE MITER BASE TO CHECK MITER FENCE ALIGNMENT TO ADJUST QUICK-STOP TO SET THE RIP FENCE SCALE INDICATOR TO THE BLADE TO USE THE RIP FENCE TO USE OUTFEED SUPPORT TO USE THE TABLE EXTENSION HEELING (PARALLELING) THE BLADE MAKING CUTS MAKING A CROSS CUT WARNING: MAKING A RIP CUT MAKING A MITER CUT MAKING A BEVEL CROSS CUT MAKING A BEVEL RIP CUT MAKING A COMPOUND (BEVEL) MITER CUT MAKING A LARGE PANEL CUT WARNING: MAKING A NON-THROUGH CUT WARNING: MAKING A DADO CUT WARNING: TO REPLACE THE BLADE TO CHECK AND ALIGN THE SPREADER, SAW BLADE, AND BLADE GUARD ASSEMBLY TO CHECK THE ALIGNMENT OF THE RIP FENCE TO THE BLADE TO SET THE BLADE AT 0 AND 45 GENERAL MAINTENANCE MAINTENANCE LUBRICATION TROUBLESHOOTING PROBLEM CAUSE SOLUTION TROUBLESHOOTING Page OPERATORS MANUAL 10 in. TABLE SAW BTS21 ONE WORLD TECHNOLOGIES, INC.