ACCESSORIES

RIP GUIDE

Use the rip guide provided, part no. 969862-009, when making long or wide rip cuts with your saw.

TO ASSEMBLE RIP GUIDE

See Figure 22.

Follow these directions to assemble the rip guide.

■UNPLUG YOUR CIRCULAR SAW.

WARNING:

Failure to unplug the tool could result in accidental starting causing serious injury.

■Place rip guide through holes in base as shown in the figure.

■Adjust rip guide to the width needed.

■Tighten rip guide knob securely.

TO USE RIP GUIDE

Follow these directions to use the rip guide.

■Secure the workpiece.

■Position the face of the rip guide firmly against the edge of workpiece.

■Guide the saw along the edge to achieve a straight rip cut.

NOTE: The guiding edge of the workpiece must be straight for your cut to be straight. Use caution to prevent the blade from binding in the cut.

DUST NOZZLE KIT

See Figure 23.

Dust nozzle kit, part no. 982829-001, is provided with your saw. As shown in the figure, the adapter fits over the dust chute which is located on the upper blade guard.The nozzle attaches to the adapter.

NOTE: If you use the nozzle, you should always connect it to a standard vacuum hose.

TO ATTACH DUST NOZZLE

Follow these directions to attach the dust nozzle.

■UNPLUG YOUR CIRCULAR SAW.

WARNING:

Failure to unplug the tool could result in accidental starting causing serious injury.

■Lift lower blade guard.

■Orient adapter to fit into the dust chute opening (1) on upper blade guard.

■Secure adapter with screw (2) provided.

■Align hole in nozzle with raised lip on adapter and snap into place (3) when using a vacuum hose.

RIP GUIDE

SCREW

RIP GUIDE

Fig. 22

ADAPTER

HOLE

DUST CHUTE

SCREW

RAISED

NOZZLE LIP

Fig. 23

20