OPERATION
SPECIFICATIONS:
Chuck | 3/8 in. Keyless | |
Motor | DC Motor 6.0V | |
|
|
|
Switch | ||
|
|
|
No Load Speed | 300/500 RPM | |
|
|
|
Clutch | 24 Positions |
|
Charger Input | 120V, 60 Hz, AC only | |
|
| |
Charge Rate | ||
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use any tool, familiarize yourself with all operating features and safety requirements.
WARNING:
TORQUE LEVEL ADJUSTMENT
RING
9 7
5
3
1 
SWITCH
TRIGGER
KEYLESS
CHUCK
BIT
STORAGE
AREA
DIRECTION OF
ROTATION
SELECTOR
Fig. 1
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.
CHARGING YOUR DRILL-DRIVER
This tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it at least 6 hours prior to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by re- charging) for them to become fully charged.
TO CHARGE
■Charge only with the charger provided.
■Connect charger to the tool by inserting charger plug into input jack. Note: As shown in figure 2, input jack is located at rear of tool.
■Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.
■Connect charger to power supply.
■The charge indicator light (LED) indicator, which is located on rear of drill, will light up when charger is properly connected to power supply. This red light indi- cates your drill is charging and will remain on until charger is disconnected from power supply.
WARNING:
BATTERY
CHARGER
CHARGE
INDICATOR
LIGHT (LED)
INPUT
JACK
CHARGER
PLUG
Fig. 2
■After normal usage, 3 hours of charging time is re- quired to be fully charged. A minimum charge time of 6 hours is required to recharge a completely discharged battery.
■The charger housing and the tool handle will become slightly warm to the touch while charging. This is nor- mal and does not indicate a problem.
■DO NOT operate drill while it is connected to the charger. The driving ability will not increase.
■DO NOT place charger in an area of extreme heat or cold. It works best at normal room temperature.
The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields.
Page 6
