Ryobi LE720r manual Operating Instructions, Operating the CLICK-LINK System

OPERATING INSTRUCTIONS

OPERATING THE CLICK-LINK® SYSTEM

The Click-Link® system enables the use of these optional add-ons.

Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r Hedge Trimmer (Gas units only) . . . . . . . . . . . . . HS720r Snow Thrower (Gas units only) . . . . . . . . . . . . . . ST720r Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . SS725r Sweeper/Blower . . . . . . . . . . . . . . . . . . . . . . . . . SB720r Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r

WARNING: Read and understand operator’s manual for unit to be used with this add-on prior to operation.

Removing the Add-Ons:

1.Turn the knob counterclockwise to loosen (Fig. 1).

2.Press and hold the release button (Fig. 1).

3.While firmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the Click-Link® coupler.

Installing the Add-Ons:

WARNING: To avoid serious personal injury, shut unit off before removing or installing add-ons.

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1. Turn the knob counterclockwise to loosen (Fig. 1).

Click-Link®Coupler Release Button

Guide

Knob Recess

Fig. 1

2.While firmly holding the add-on, push it straight into the Click-Link® coupler (Fig. 2).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 2).

Click-Link®Coupler Release Button

Primary Hole

Upper Shaft		Lower Shaft
Housing
		Housing
	Fig. 2

3. Turn the knob clockwise to tighten (Fig. 3).

CAUTION: Lock the release button in the primary hole and securely tighten the knob before operating this unit.

Knob

Fig. 3

CAUTION: The add-ons with the Click-Link® system are to be used in the primary hole unless stated otherwise in the specific add-ons operator’s manual. Using the wrong hole could lead to personal injury, or damage to the unit.

The edger add-on should be installed with the release button in the primary hole.

6