OPERATION
SETTING DEPTH
See Figure 6.
The depth adjustment knob increases or decreases the force with which a staple is driven into the workpiece.
Rotate the depth adjustment knob clockwise to increase the force.
Rotate depth adjustment knob counterclockwise to decrease the force.
Test on a scrap piece of the same material you are using to achieve the desired depth.
NOTE: Harder materials will require more force to drive a staple.
STAPLING
See Figure 7.
Hold handle firmly with magazine flat to workpiece, forming a 90º angle.
Press the activation foot of the stapler down against the workpiece. The activation foot must be depressed before the switch trigger is depressed.
NOTE: The tool will drive another staple each time the trigger is depressed as long as the activation foot is depressed.
REMOVING A JAMMED STAPLE
Remove battery pack from the tool.
Hold tool upside down; squeeze latch and slide base open.
Remove unused staples from magazine.
Remove jammed staple with needle nose pliers.
NOTE: You must remove jammed staple before using tool any further. If you try to drive a staple while the tool is jammed, you could cause damage to the mechanism.
INCREASE
FORCE
DEPTH
ADJUSTMENT
KNOB DECREASE 
FORCE
Fig. 6
90
Fig. 7
12
