10
OPERATION
WARNING:
Always wear safety goggles or safety glasses with side
shields when using your router. Failure to do so could
result in dust, shavings, chips, loose particles, or foreign
objects being thrown in your eyes resulting in possible
serious injury. If the operation is dusty, also wear a face
or dust mask.
TURNING THE ROUTER ON/OFF

See Figure 2.

■

To turn on the router:

Move the switch to the I position.
■

To turn off the router:

Move the switch to the O position.
OPERATING THE ROUTER

See Figure 3.

Follow these steps to operate the router.
1. Unplug the router.
WARNING:
Failure to unplug the tool could result in accidental start-
ing causing serious injury.
2. Securely tighten the cutter in the collet nut. Refer to
“Removing/Inserting Cutters” later in this manual.
3. Set the desired depth of cut. Refer to “Adjusting Depth
of Cut” later in this manual.
4. Secure the workpiece.
5. Plug the router into a power source.
6. Hold the router firmly with both hands.
7. Turn on the router and let the motor build to its full
speed.
8. Feed the cutter slowly into the workpiece.
NOTE: Do not let the cutter contact the workpiece
before starting the router and allowing it to develop full
speed.
9. Turn off the router upon completion of cut, and let the
motor come to a complete stop before removing the
router from the workpiece.
WARNING:
Never place the router down on a work surface before the
cutter stops.
Fig. 2
Fig. 3
OFF
ON
WARNING:
Never attempt to use the router motor without first install-
ing it in one of the approved bases. Failure to heed this
warning could result in personal injury or damage to the
motor.