ASSEMBLY
Inspect the product carefully to make sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have care- fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
Packing List
Blower
Upper Blower Tube Sweeper Nozzle
Upper and Lower Vacuum Tubes Vacuum Tube Screws (2) Vacuum Bag
Vacuum Bag Adaptor
NOTE: Read and remove all hang tags and store with your Operator’s Manual.
Installing the vacuum bag
See Figures 5 - 6.
Remove the nozzle and upper blower tube from the blower by twisting and removing from blower housing outlet.
Unzip the vacuum bag and push the vacuum bag adaptor through the opening opposite the zipper as shown. The wider end of the adaptor will remain on the inside of the vacuum bag when installed properly.
Align the raised slots on the vacuum bag adaptor with the raised locking tabs on the blower housing outlet. Push the vacuum bag adaptor onto the housing and twist to lock into place.
Rotate the vacuum bag until the shoulder strap is upright.
Make sure the vacuum bag is zipped and closed before starting the unit.
Installing the vacuum tubes
See Figures 7 - 8.
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of the product with damaged or missing parts could result in possible serious personal injury.
WARNING:
Contact with rotating impeller blades could result in seri- ous personal injury. Always stop the engine and ensure impeller blades have stopped rotating before opening the vacuum door or installing/changing tubes. Do not put hands or any other object into the vacuum tubes while they are installed on the unit.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
ASSEMBLING THE BLOWER TUBES
See Figures 3 - 4.
Align raised tabs on blower housing outlet to the slots on upper blower tube; slide together and tighten securely by twisting. Check tightness after initial use and retighten if needed.
Attach sweeper nozzle to upper blower tube by aligning raised tabs on upper blower tube; slide together and tighten securely by twisting. Check tightness after initial use and retighten if needed.
To remove the tubes, rotate the tubes to unlock them and remove from the blower housing outlet.
To install the vacuum tubes:
Secure the upper and lower vacuum tubes together by aligning the raised locking tabs with the raised slots.
Tap tube assembly on ground until the screw holes in lower tube are in the raised slot of the upper tube. Secure with supplied screws.
Depress door tab using a flathead screwdriver and open vacuum inlet door.
Align screw mounts on vacuum opening with screws on vacuum tube assembly.
Turning clockwise, tighten screws on upper vacuum tube to secure to blower housing.
To remove the vacuum tubes:
Loosen screws of the upper vacuum tube by turning counterclockwise.
Remove the vacuum tube assembly from the blower housing.
Close the vacuum inlet cover door securely.
7 - English
