| FEATURES |
|
|
PRODUCT SPECIFICATIONS |
|
Weight | .....................................................................................4 lbs. |
Blade Length | 9 in. |
Edging Depth | Adjustable from 1/2 in. to |
KNOW YOUR EDGER ATTACHMENT |
|
See Figure 1. |
|
The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules.
ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully remove the items from the box. Make sure that all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury.
nInspect the product carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
nIf any parts are damaged or missing, please call
PACKING LIST
Edger Head
Edger Attachment Shaft
Holding Pin
Hex Wrench
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
Do not connect to power head until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury.
JOINING THE EDGER ATTACHMENT TO THE ATTACHMENT SHAFT
See Figure 2.
This product requires a one
Remove rubber end cap from edger attachment shaft before installing.
Install the edger attachment shaft into opening on the gear head so that the hole on the top of the attachment shaft lines up with the shaft screw. Be sure the arrows on the gear head and the edger attachment shaft meet.
Tighten the shaft screw into the hole on the edger attachment shaft.
NOTE: When the screw is properly installed the screw head will be completely seated against the casting. If this is not the case, the screw is not installed properly.
Tighten securely by turning the gear head screw to clamp gear head around shaft.
NOTE: When fully secure, the shaft cannot be rotated.
6 — English