| TABLE OF CONTENTS |
|
■ | Table of Contents | 2 |
■ | Accessories | 2 |
■ | Unpacking | 2 |
■ | General Safety Rules | 3 |
■ | Specific Safety Rules | |
■ Important Safety Instructions For Charger | ||
■ | Symbols | 7 |
■ | Features | 8 |
■ | Operation | |
■ | Maintenance | 19 |
■ Battery Pack Preparation For Recycling | 19 | |
■ Parts Ordering / Service | 20 | |
Look for this symbol to point out important safety precautions. It means attention!!! Your safety is involved.
ACCESSORIES
The following recommended accessories are current and were available at the time this manual was printed.
■
■Optional Rip Guide
UNPACKING
Your circular saw has been shipped completely assembled except for the blade. Inspect it carefully to make sure no breakage or damage has occurred during shipping. If any partsaredamagedormissing,contactyournearest Authorized Service Center to obtain replacement parts before attempting to operate saw. A blade, blade wrench, and this operator's manual are also included.
WARNING:
If any parts are missing, do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury. If any parts are damaged or missing, please contact
WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. Always use eye protection which is marked to comply with ANSI Z871.1.
Page 2
