OPERATION
ORBITAL MOTION
Orbital motion is ideal for fast cutting action when removing old finishes, smoothing rough wood, cutting stock down to required dimensions, or for finishing surfaces to be painted. As shown in figure 6, the sandpaper moves in tiny circles at a very high speed, allowing the sander to move easily.
WARNING:
Collected sanding dust from sanding surface coatings such as polyurethanes, linseed oil, etc. can
USING THE DUST BAG ASSEMBLY
The dust bag assembly provides a dust collection system for the sander. Sanding dust is drawn up through the holes of the sanding disc and collected in the dust bag during sanding.
TO ATTACH THE DUST BAG ASSEMBLY
See Figure 7.
Follow these directions to attach the dust bag assembly.
■Unplug the sander.
WARNING:
Failure to unplug the tool could result in accidental starting causing possible serious injury.
■Slide the dust bag assembly onto the blower exhaust on the sander using a slight twisting motion.
TO EMPTY THE DUST BAG ASSEMBLY
See Figure 7 and 8.
For more efficient operation, empty the dust bag when it is no more than half full. This will permit the air to flow through the bag better. Always empty and clean the dust bag thoroughly upon completion of a sanding operation and before placing the sander in storage.
TO EMPTY DUST BAG
■Unplug your sander.
WARNING:
Failure to unplug your sander could result in accidental starting causing possible serious personal injury.
■Remove the dust bag assembly from the sander.
■Remove the dust bag from the frame.
■Shake out the dust.
■Replace the dust bag on the frame.
■Replace the dust bag assembly on the sander.
Page 10
ORBITAL MOTION
Fig. 6
DUST BAG
ASSEMBLY
Fig. 7
DUST BAG
DUST BAG FRAME
Fig. 8
