Ryobi TECHNOLOGIES, INC | Ryobi VC722VC120 specification

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING HAND VAC

WARNING:

To reduce the risk of fire, electric shock, or injury, read and understand all instructions in this operator’s manual and the operator’s manual for the hand vac before using hand vac, changing attachments, filters, or making adjustments.

■Do not use outdoors or on wet surfaces.

■Use only as described in this manual. Use only with the VC722 or VC120 Hand Vac.

■Do not allow to be used as a toy. Close attention is necessary when used by or near children.

■Keep hair, loose clothing , fingers, and all parts of the body away from openings and moving parts.

■A cordless hand vac does not have to be plugged into an electrical outlet, therefore it is always in operating condition. Be aware of possible hazards when using your hand vac or when changing accessories.

■DO NOT PLACE BATTERY PACK NEAR FIRE OR HEAT. The batteries may explode.

SAVE THESE INSTRUCTIONS

REPLACING FILTER

See Figures 1 & 2.

REATTACHING DUST BOWL

See Figure 3.

■Position the two sections as shown. Align slots on bottom of dust bowl with tabs on bottom of motor housing then snap the two sections together.

DEPRESS RELEASE BUTTON

PULL DUST BOWL	DUST BOWL
PULL DUST BOWL
DOWN AND OUT
TO REMOVE		Fig. 1
	FILTER	HAND VAC

DUST BOWL

BATTERY

WARNING:

Never use your hand vac without dust bowl and filter properly in place.

REMOVING DUST BOWL

NOTE: The dust bowl should be checked, emptied and cleaned periodically to obtain maximum dust collection.

■ Turn off hand vac and remove battery pack before

changing attachments, filters, or making adjustments.

■ Depress the release button located on top of hand vac.

Pull dust bowl down and out to separate from motor

PACK

SLOTS TABS

Fig. 2

Fig. 3

housing.

■ Remove the filter by pulling it out of dust bowl

■ Dispose of filter.

■ Empty dust bowl and wash if necessary. Make sure dust

bowl is completely dry before reattaching to hand vac.

■ Insert new filter into dust bowl as shown in Figure 2.