Ryobi YN200BND Operation, Applications, Preparing the tool for use, No-MAR Nosepiece

OPERATION

DANGER:

Do not use oxygen, combustible gases or bottled gases as a power source for this tool. The tool will explode and cause death or serious injury.

WARNING:

Always wear eye protection. Eye protection does not fit all operators in the same way. Make sure the eye protection chosen has side shields or provides protection from flying debris both from the front and sides.

WARNING:

Do not allow familiarity with tools to make you careless. Remember that a careless ­fraction of a second is sufficient to inflict severe injury.

WARNING:

Always wear eye protection with side shields marked to comply with ANSI Z87.1 along with hearing and head protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.

WARNING:

Disconnect the tool from the air supply before leaving the work area, moving the tool to another location, or handing the tool to another person. Failure to do so could result in serious personal injury.

APPLICATIONS

You may use this tool for the purposes listed below:

PREPARING the tool for use

See Figure 2, page 15.

Under normal use conditions, the tool should be lubricated before connecting the tool to an air supply. Add air tool oil into the air fitting on the tool once daily with minimal use, or twice a day with heavy use. Only a few drops of oil at a time is necessary. Too much oil will only collect inside the tool and will be noticeable in the exhaust cycle.

Before connecting the tool, check the air compressor gauge to be sure it is functioning within the proper range of 70-120 psi.

no-MAR NOSEPIECE

See Figure 3, page 15.

The no-mar nosepiece attached to the workpiece contact of the tool helps prevent marring and denting when working with softer woods.

WARNING:

Disconnect the tool from the air supply before removing or replacing the no-mar nosepiece. Failure to do so could result in serious personal injury.

Finish and Trim (interior and exterior)

Decorative Trim

Book Cases

Baseboard

Cabinets

Case Backs

Drawers

Molding

Mirror and Picture Frames

Paneling

Shoe & Base Moldings

Staircases

Upholstery Trim Panels

Wainscoting

Window Beading

Chair Rail

Furniture Frames

Lattice Strip Molding

Nailable Plastic Parts

Crafts

The no-mar nosepiece can be removed by pulling it down and away from the nose. To replace the no-mar nosepiece, fit it into place over the workpiece contact and push up at the back to reseat.

ADJUSTing the EXHAUST

See Figure 4, page 15.

The adjustable exhaust on the end cap of the tool allows the operator to direct the exhaust according to operator preference. To adjust, turn the exhaust cap until the exhaust blows in the desired direction.

9 - English