TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACTYOUR AUTHORIZED SERVICE DEALER.
PROBLEM | POSSIBLE CAUSE | SOLUTION | ||
|
|
|
|
|
Engine will not start: | 1. No spark. | 1. Check spark. Remove spark plug. Reattach the | ||
|
| spark plug cap and lay spark plug on metal | ||
|
| cylinder. Pull the starter rope and watch for | ||
|
| spark at spark plug tip. If there is no spark, | ||
|
| repeat test with a new spark plug. | ||
| 2. No fuel. | 2. Push primer bulb until bulb is full of fuel. If bulb | ||
|
| does not fill, primary fuel delivery system is | ||
|
| blocked. Contact a servicing dealer. If primer | ||
|
| bulb fills, engine may be flooded (see next | ||
|
| item). | ||
| 3. Flooded engine. | 3. Remove spark plug, turn trimmer so spark plug | ||
|
| hole is aimed at the ground. Make sure lever is | ||
|
| in the “WARM START” position and pull starter | ||
|
| cord 10 to 14 times. This will clear excess fuel | ||
|
| from engine. Clean and reinstall spark plug. | ||
|
| With the throttle trigger fully depressed, pull | ||
|
| starter cord three times with lever at “WARM | ||
|
| START” position. If engine does not start, | ||
|
| move choke lever to “COLD START” and follow | ||
|
| normal starting instructions in "STARTING | ||
|
| AND STOPPING" section. If engine still fails to | ||
|
| start, repeat procedure with a new spark plug. | ||
| 4. Starter rope pulls harder now than | 4. Contact a servicing dealer. | ||
| when new. |
|
|
|
|
|
|
| |
Lever will not go into the | Throttle trigger is depressed. | Release throttle trigger. Refer to “Starting and | ||
"COLD START" position: |
| Stopping” earlier in this manual. | ||
|
|
|
| |
Engine starts but will not | Carburetor requires adjustment. | *Turn “L” needle counterclockwise 1/16 turn. If | ||
accelerate: |
| “L” low needle can not be turned counterclock- | ||
|
| wise, do not force plastic limiter caps. Contact a | ||
|
| servicing dealer. See Figure 25. | ||
|
|
|
| |
Engine does not reach full | 1. Check oil fuel mixture. | 1. Use fresh fuel and the correct | ||
speed and emits excessive | 2. Air filter dirty. | 2. Clean air filter. Refer to “Replacing and | ||
smoke: |
| Cleaning Air Filter” earlier in this manual. | ||
| 3. Carburetor requires adjustment. | 3. Turn “H” needle clockwise 1/16 - 1/8 turn. See | ||
|
| Figure 25. | ||
|
|
|
| |
Engine starts, runs, and | Carburetor requires adjustment. | Turn idle speed screw clockwise to increase | ||
accelerates but will not |
| idle speed. See Figure 25. | ||
idle: |
|
|
|
|
|
|
|
| |
Blade continues to rotate at | Carburetor requires adjustment. | Turn idle speed screw counterclockwise to reduce | ||
idle speed: |
| idle speed. See Figure 25. If after adjustment, | ||
|
| blade continues to rotate, return to an authorized | ||
|
| servicing dealer for repair. | ||
|
|
|
|
|
19
