Mast Base
The mast step bolt should be in the 6th hole from the back. The rig tension bolt should be in the 3rd hole from the back.
Spreader Length and Marks
The spreader length should be 505mm from side of mast to centre of shroud wire, this is the 5th pin hole position. Mark the spreaders every two cm’s from the centre of the shroud wire, this can be used for the jib trim with regard to the leech settings.
Trapeze System
The trapeze ropes and blocks are pre assembled, in the fitting bag. Once you get them out, shackle them on the trapeze wires and hook them onto the trapeze elastic loops as shown, by feeding the elastic bowline through the hole and over the edge of the ring.
