P2600 Rumble Force PAD Getting Started

P2600 RUMBLE FORCE PAD

GETTING STARTED

Installation for Users of Windows® XP

A) Drivers Only For Typical Users

1.With your computer switched on, close down any programs that are currently running and insert the Saitek Smart Technology CD into your CD-ROM drive.

2.When the Introduction Screen appears, click Install Software to continue. If the CD does not run automatically, select Start from the Windows® Taskbar, then Run and type D:\Setup.exe and click OK - where D:\ is letter of your CD-ROM drive.

3.When the Welcome screen appears, click Next to continue.

4.After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click Next to continue.

5.At the Driver Setup screen, if you haven't already done so, plug the USB cable into one of your computer's USB ports and click on Next.

6.At the Driver Setup screen, click Next to test your controller.

7.When the Saitek Controller screen appears, try out all your controller's buttons and controls to show that it is working properly. When you have finished, click OK.

8.At the Software Setup screen, select Do not install the SST Programming Software and click Next. The Programming Software can be installed at a later date by following instruction (B). below

9.At the Registration screen, select Check this box to register now and follow the on-screen instructions, or you can choose to select this option later. 10.Click on Finish to complete the installation.

B) Drivers and Programming Software For Advanced Users

Follow points 1 - 7 of the install procedure in A), then at the Software Setup screen, select Install the SST Programming Software and click Next.

In the following Software Setup screen, click Next and follow the on-screen instructions. At this point you will be asked to install such features as the Saitek Magic Mouse, HID-compliant mouse, Saitek Magic Keyboard and HID Keyboard Device (these are what XP calls the various elements of your Saitek controller). Continue to click on Next and Finish to accept the installation until the Registration screen appears.

At the Registration screen, select Check this box to register now and follow the on-screen instructions, or do not select this option and register later.

Upon completion of the installation, you have the option to Run Profile Editor, which will give you a view of the 3D programming environment. If you do not wish to see the Profile Editor at this point, just uncheck the box and click on Finish to complete the installation.

Installation for Users of Windows® 2000