How to Clean
1.Move the Rocker Switch to the Off position and wait for the motor to stop completely.
2.Unplug from the wall outlet.
3.Disassemble the Juicer (see directions above)
4.Clean the Pulp Container, Pulp Chute/Juicer Cover, Food Pusher, Juice Collector, Juice Jug and Froth Separator in warm, soapy water. A mild detergent is recommended. Rinse well and dry thoroughly.
5.Hold the Stainless Steel Strainer Basket/Cutting Blades under clean running water. If needed, use a small brush to gently clean away pulp from the filter and cutting blades. Rinse under running water. Hold the Strainer Basket/Cutting Blades up to the light to ensure that the fine mesh holes are not blocked. If the holes are blocked, soak the Strainer Basket/Cutting Blades in hot water to loosen the pulp and clean with the brush again. Allow to dry on a cloth or paper towel before reassembling the juicer.
CAUTION: THE CUTTING BLADES ARE VERY SHARP.
6.Wipe the Motor Housing with a soft cloth moistened in warm soapy water.
NEVER IMMERSE MOTOR HOUSING IN WATER OR ANY OTHER LIQUID.
TROUBLESHOOTING
PROBLEM | SOLUTION | |
Juicer will not operate when | The safety locking arm may not be correctly | |
engaged into the 2 grooves on either side of the | ||
switched on. | ||
Pulp Chute/Juicer Cover. | ||
| ||
|
| |
| Push the Food Pusher down slowly so that wet pulp | |
Motor stalls when juicing | does not build up under the Pulp Chute/Juicer | |
| Cover. Choose Hi speed instead of Lo speed. | |
|
| |
Excess pulp building up in filter | Alternate soft and hard fruit and vegetables | |
|
| |
| Use Lo speed. Check to be sure that the holes in | |
Pulp too wet | the mesh filter are not blocked. If they are blocked | |
| follow #5 in the How to Clean section. | |
|
| |
Juice leaks between the rim of the | Use Lo speed. Fruits and vegetables with a high | |
Juicer and Pulp Chute/Juicer Cover | water content should be juiced on Lo speed. | |
|
|
8
