Salton WT50BL, WT50GY, WT50OR, WT50PB, WT50PL, WT50RD WALL MOUNTING WITH ADHESIVE, WALL MOUNTING WITH SCREWS

WALL MOUNTING WITH ADHESIVE

1. Select a spot on the wall that is as smooth as possible, such as a

smooth ceramic tile. Thoroughly clean the spot of all soap, oil or

other films using a household cleaning solvent such as Acetone or

nail polish remover. DO NOT use the tile cleaner or other wax-

based substances. Allow area to dry completely. Room

temperature should be at 60 to 70ºF.

2. For best results, hold adhesive tube (supplied) at a 45-degree angle

and apply sealant to Mounting Plate, approximately 1/8” bead and

1/4” from edges. Use entire contents. If additional adhesive is

required, use silicone caulking compound or you may order extra

adhesive packets. (P/N 01005)

3. Place Mounting Plate against clean wall surface using enough

pressure to displace air, but not adhesive.

4. Allow adhesive to cure for 24 hours.

5. Slide the Radio onto the secured Mounting Plate.

WALL MOUNTING WITH SCREWS

1. Place Mounting Plate against a clean wall surface and mark the

spots on the wall where you will be drilling. Remove the Mounting

Plate from the wall.

2. Drill 4 holes in the wall that match the placement of the holes in the

Mounting Plate.

3. Insert a Screw Socket into each of the 4 holes.

4. Place Mounting Plate against the wall in the correct position and

drill in the 4 Screws.

5. Slide the Radio onto the secured Mounting Plate.

*Color reference: BL, OR, PL, RD, GY, PB.

4 Mounting

Screws

4 Screw

Sockets

Wall

Mounting

Plate

(10040*)

Earphone

Jack

Adhesive

Bead