Samson B90 owner manual Guided Tour Rear Panel

Guided Tour - Rear Panel

1 2

E	S U F	CAUTION	Hartke	B90
		WARNING
		AVIS
		ATTENTION			SERIAL
			90 WATT BASS AMPLIFIER		NUMBER

3 4

EFFECTS LOOP

PREAMP	AMP IN
OUT

ENGLISH

1.Fuse holder (B60, B90 and B120 only) - Holds an appropriately rated fuse for your model. If you need to change this fuse for any reason, replace it with one that has the same exact rating:

B60: 2.0 amp for 115 volt operation; 1.0 amp for 230 volt operation

B90: 3.0 amp for 115 volt operation; 1.6 amp for 230 volt operation

B120: ?? amp for 115 volt operation; ?? amp for 230 volt operation

2.AC Power Cord - Use this permanently attached grounded AC power cord to connect your B Series amplifier to mains power. This cord comes supplied with the appropriate plug for your geographic area. CAUTION: Do not use an adapter to defeat the third grounding pin on this plug or severe electric shock may result!

3.Preamp Out (Effects Loop Send)- Use this 1/4" unbalanced jack to send signal to a professional outboard effects processor.* Output level is approximately 0 dB to +4 dB and is post-EQ and post-Shape but unaffected by the setting of the Volume control. The signal from this output is the same as that from the Line Out on the front panel (see #7 on page 4).

4.Amp In (Effects Loop Return)- Use this 1/4" unbalanced jack to return signal from a professional outboard effects processor.*

*In-line effects (such as footpedals) intended for low signal levels should be placed between your bass and the front panel B Series amplifier Input and not connected with the rear panel Effects Loop jacks.

7