![Operating the EX500](/images/new-backgrounds/10589/1058917x1.webp)
Operating the EX500
EX500 CONTROL PANEL
The EX500’s control panel provides the connections and user interface to the EX500’s internal electronic crossover and power amplifier section. The internal amplifier is a 500 Watt tracking amplifier capable of producing incredible bass output while running super cool, and at the same time, weighing half as much as conventional power amplifiers. EX500 employs an electronic crossover that adjusts the high frequency cutoff point for the sub- woofer, and also, a high passed output for your satellite speakers. You will achieve a tremendous benefit in sound quality by running your satellite speakers from the EX500’s
Level Control
The level control is used to adjust the amount of volume from the EX500 subwoofer. In addition, the Level control will also control the output volume of the
Sweep
|
|
|
|
|
| BALANCED INPUTS | BALANCED HIGH PASS OUTPUTS |
|
|
|
| Hz |
|
|
|
| 5 |
| 105 |
|
|
| |
• | • |
| • | • | PEAK STEREO |
|
|
|
|
|
|
|
|
| |
• | • • |
|
| • |
|
| |
• | • |
| • | • | MONO |
|
|
|
|
|
| ||||
0 | 10 | 30 | 200 | LEFT RIGHT | LEFT RIGHT | ||
LEVEL |
| SWEEP |
| ||||
|
|
|
|
P O W E R E D S U B W O O F E R 5 0 0 WAT T S
The Sweep control selects the upper range cutoff frequency of the EX500’s internal electronic crossover. The EX500’s crossover provides a 12dB per octave Linkwisz- Riley filter curve. The Sweep limits the high frequency that the EX500 will reproduce, and at the same time, the
Stereo / Mono Switch
The Stereo/ Mono switch selects either stereo or mono bass operation. When set to MONO, the EX500 will com- bine, or sum, the left and right signals and send a mono signal to the amplifier of the EX500. In this mode, the original stereo signal is passed through the left and right outputs only now the stereo signal is filtered at the fre- quency set by the sweep control. In Stereo mode, the low frequency signal is not summed, and you can choose either the left or right input accordingly for each side of the system.
The In and The Outs
The EX500 feature electronically balanced inputs and outputs so that any possible HUM problems are greatly reduced when interfacing to other equipment. XLR connectors with industry standard pin- outs are used for easy interface from mixer and other professional audio gear. A detailed wiring diagram can be found in the section EX500 Connections on page 12 of this manual.
7