E
19
4. Operation Function Instruction!INITIAL STATUS
● If you turn on this monitor, it search cameras.
● If all cameras weren't connected to monitor, this screen display channel 1.
@SEQUENTIAL SWITCHING MODE
● Please press AUTO button, the monitor goes to sequential switching mode and the yellow
LED lamp of AUTO button will on.
● The sequential switcher built in the monitor allows each camera to show the pictures
sequentially.
● If a camera is disconnected from the monitor, it will be skipped and the deep sounds.
● If camera 2 and camera 4 are connected to monitor, this is switched on sequence of camera
2, camera 4.
● If all cameras were disconnected to monitor in AUTO mode, monitor displays channel 1.
● The switching time can be adjusted from 1 to10 seconds by using time button.
● Initial dwell time is 2 seconds.
● If you want manually select camera, please press camera select button.
#ALARM FUNCTION
● When the alarm is triggered, its signal goes to the monitor and the monitor shows the
triggered camera picture on the screen.
● When two or more cameras are triggered at the same time, the monitor shows finally
triggered camera picture.
● To reset alarm in case of alarm triggering, press TALK(A.RESET) key.
● Once the alarm is released, the monitor goes back to the previous mode automatically.
● If you make the alarm off in the VCR mode, the system doesn't go back to the VCR mode. It
goes back to more previous state than the VCR mode.
● To disable the alarm completely(the alarm is not detected), set alarm lamp off by using alarm
button.
● Alarm time is 12 seconds.
$VCR MODE
● To see the recorded picture, press the VCR key on the system
%AUDIO SYSTEM
● This monitor has two way audio system.
● When a camera picture appears on the screen, you can hear the sound from the camera's
microphone though the speaker built in the monitor.
● If you want to talk to camera 2, please select it and go on pressing TALK button and talk.