User’s Manual
Information
•FCC Information
User Instructions
The Federal Communications Commission Radio Frequency Interference Statement includes the following
warning:
Note: This equipment has been tested and found to comply with the limits for a Clas s B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea sonable protection against
harmful interference in a residential installation. This equipment gen erates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the ins tructions, may cause harmful
interference to radio communications. However, there is no guarantee that int erference will not occur in a
particular installation. If this equipment does cause harmful interferenc e to radio or television receptions,
which can be determined by turning the equipment off and on, the user is encour aged to try to correct the
interference by one or more of the following measures:
.Reorient or relocate the receiving antenna.
.Increase the separation between the equipment and receiver.
.Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
.Consult the dealer or an experienced radio/TV technician for help.
User Information
Changes or modifications not expressly approved by the party responsibl e for compliancecould void the
user's authority to operate the equipment. If necessary, consult your dealeror an ex perienced radio/television
technician for additional suggestions. You may find thebooklet called How to Identify and Resolv e Radio/TV
Interference Problems helpful. This
booklet was prepared by the Federal Communications Commission. It is available from the U.S. Govern ment
Printing Office, Washington, DC 20402, Stock Number 004-000-00345-4
Warning
User must use shielded signal interface cables to maintain FCC compliance fo r the product.
Declaration of conformity for products Marked with FCC Logo
This device complies with Part 15 of the FCC Rules. Operation i s subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must a ccept any interference received,
including interference that may cause undesired operation.
The party responsible for product compliance:
SAMSUNG ELECTRONICS CO., LTD
America QA Lab of Samsung
85 West Tasman Drive
San Jose, CA 95134 USA
Tel) 408-544-5124
Fax) 408-544-5191
Provided with this monitor is a detachable power supply cord with IEC320 st yle terminations. It may be
suitable for connection to any UL Listed personal computer with similar configuration. Before making the
connection, make sure the voltage rating of the computer convenience o utlet is the same as the monitor and
that the ampere rating of the
computer convenience outlet is equal to or exceeds the monitor voltage rating. For 120 Volt app lications, use
only UL Listed detachable power cord with NEMA configuration 5-15P type (parallel blades) plug cap . For 240
Volt applications use only UL Listed Detachable power supply cord with NE MA configuration 6-15P type
(tandem blades) plug cap.
Regulatory