OPERATING GUIDE

CONNECTING TO YOUR COMPUTER

Signal Input

Power (

On/Off)

AC Cord Inlet

 

 

dicator

 

Power In

 

 

 

 

 

This monitor can be connected to any IBM compatible analog display adapter.

Such adapters include VGA, 8514/A, XGA, and the built-in video system of IBM PS/2 computers and compatibles.

To attach the monitor to your system, use the following instructions:

1.Turn off the power to the computer.

2.Insert the AC power cord into monitor and then into an AC power outlet.

3.Connect the 9-pin side of the signal cable to the 9-pin D-SUB connector on the rear side of the monitor.

4.Connect the 15-pin side of the signal cable to the video output port of your video controller.

Note: Please see the connector pin assignment chart for the video controller (video controller manual) and the connector pin assignment chart for the monitor (Page 10 this manual) if the video controller does not have a standard 15 pin D-SUB connector.

5.Before turning on the power to the monitor and computer, check your computer’s owner’s manual for instructions about turning on equipment connected to the computer. Also, check for any instructions for your video system when using a multi-sync monitor. In some cases, jumper or switch settings may be required for the video board to output extended resolution modes.

6.To turn on the monitor, push the power switch. The power indicator LED will light. To turn the monitor off, push the power switch once again. The power indicator LED will also turn off.

6