143
Settings
6
6 Settings

6.11.4 Standby Control

You can set the screen standby mode to be applied when an input signal is received.

Setting Standby Control

1Press MENU on the remote control.
2Press / to move to Setup and press [ ].
3Press / to move to Advanced Settings and press [ ].
4Press / to move to Standby Control and press [ ].
5Press / to move to the option you want and press [ ].
zAuto
Power-saving mode will activate if no input signals are detected even though a source device is
connected to the display.
The message "No Signal" will appear if no source device is connected.
zOn
Power-saving mode will activate if no input signals are detected.
zOff
The message "No Signal" will appear if no input signals are detected.
6The selected option will be applied.
zThe Standby Control option is only enabled when Source is set to PC or DVI.
zIf "No Signal" is displayed although a source device is connected, check the cable connection.
Refer to page 56 for details about connecting source devices.
S t a n d b y C o n t r o l
M o v e E n t e r R e t u r n
A u t o
O f f
O n