29
English
04 Advanced Features
Network Setup (Samsung Auto Configuration)
The Samsung Auto Configuration function lets you connect
your Samsung TV automatically to non-Samsung wireless
APs. If your non-Samsung AP does not support Samsung
Auto Configuraton, you must connect using one of the
other methods: PBC (WPS), auto configuration, or manual
configuration.
✎
To use this function, you must set SWL (Samsung
Wireless Link) to Off in the T V’s on-screen menu.
✎
You can check for equipment that suppor ts Samsung
Auto Configuration on www.samsun g.com.
How to set up using Samsung Auto Configuration
1. Place the AP and TV next to each other and turn them
on.
✎
Because AP booting times vary, you may have
to wait approximately two minutes for your AP to
boot up.
✎
Ensure the LAN cable is connec ted to the
WAN port of the AP during Samsung Auto
Configuration. If it is not connected, S amsung
Auto Configuration only confir ms that the TV is
connected to the AP, but does not confirm it is
connected to the Internet.
2. After 2 minutes, connect the Samsung Wireless LAN
Adapter to the TV. When the Samsung Wireless LAN
Adapter establishes a connection with your TV, a pop-up
window appears.
3. As soon as a connection is established, place the AP
parallel to the Samsung Wireless LAN Adapter and not
farther than 9 and 7/8s inches (25cm) from it.
4. Wait until the connection is automatically established.
✎
If Samsung Auto Configuration doe s not connect
your TV to your AP, a pop-up window appears on
the screen notifying you of the failu re. If you want
to try using Samsung Auto Configur ation again,
reset the AP, disconnect the Samsung Wireles s
LAN Adapter and then try again f rom Step 1. You
can also choose one of the other conne ction
setup methods: PBC (WPS), auto, or manual.
5. Place the AP in a desired location.
✎
If the AP settings change or you instal l a new
AP, you must perform the Samsung Auto
Configuration procedure agai n, beginning from
Step 1.
Notice
The picture may appear corrupted or have static for some channels when the TV is connected to the Samsung Wireless LAN
Adapter. In such a case, establish a connection using one of the following methods or connect the Samsung Wireless LAN
Adapter using a USB cable in a place that is not affected by radio interference.
Method 1 Method 2
Connect using the USB right angle adapter Connect via an extension cable
To connect the Samsung Wireless LAN Adapter using the
USB right angle adapter, follow these steps:
1. Connect the USB right angle adapter to the Samsung
Wireless LAN Adapter.
2. Connect the other end of the right angle adapter to the
USB 1 (HDD) port.
To reconnect the Samsung Wireless LAN Adapter using the
extension cable, follow these steps:
✎
The Samsung Wireless LAN Ad apter should be installed
in an interference-free area in o rder to avoid interference
between the adapter and tuner.
1. Connect the extension cable to the USB 1 (HDD) port.
2. Connect the extension cable and Samsung Wireless LAN
Adapter.
3. Attach the Samsung Wireless LAN Adapter to the back
of the TV near the top, using double-sided adhesive
tape.
or
1_BN68-02870A-03Eng.indd 29 2010-06-30 오후 3:01:42