Installing and connecting the drain hose of the outdoor unit
While heating, ice may accumulate. During the process of defrosting, check if condensation draining is adequate. For adequate draining, do the following.
1. Insert the drain plug into the drain hole on the underside of the outdoor unit.
• To avoid drain plug from contacting the ground, secure gap between the |
| Drain plug | |
ground and the bottom surface of the outdoor unit. | Drain hole | ||
| |||
|
| ||
| Bottom surface of outdoor unit | ||
2. Connect a drain hose to the drain plug.
Drain hole |
|
Drain plug | Drain hose |
t05s In llan atio
3. Ensure that condensation draining is adequate.
• In areas with heavy snow fall, piled snow could block the air intake.
To avoid this incident, install a frame that is higher than estimated snow fall. In addition, install a
Estimated
snow fall Frame
Ground 
Evacuating the connected pipes
The outdoor unit is loaded with sufficient
You should evacuate the air in the indoor unit and in the pipe. If air remains in the refrigerant pipes, it affects the compressor. It may cause reduction of cooling capacity and malfunction.
• When installing, make sure there is no leakage. When recovering the refrigerant, ground the compressor first before removing the connection pipe. If the refrigerant pipe is not properly connected and the compressor works with the service valve open, the pipe inhales the air and it makes the pressure inside of the refrigerant cycle abnormally high. It may cause explosion and injury.
English-45
11/09/2013 21:11:19
