Selecting the Heat Mode
You can select the Heat mode if you want to heat your room. You can adjust the temperature and the fan speed when heating.
1 If necessary, press the 
(On/Off) button.
Result: ◆ The operation indicator on the indoor unit lights up.
◆ The air conditioner starts up in the mode you selected last. ◆ The indoor unit beeps.
2Press the 
button on the remote control until 
is displayed.
Result: | ◆ The indoor unit beeps each time you press the | button. |
◆The air conditioner runs in the Heat mode.
Note You can change modes at any time.
3Press the 
button to adjust the temperature until the required tem perature is displayed.
You can set the temperature between 16°C and 30°C.
Result: ◆ Each time you press the 
button:
-The temperature is adjusted by 1°C
-The indoor unit beeps
◆If the room temperature reaches 5°C higher than the set temperature, the air conditioner stops heating, but the fan operates consistently.
◆If the room temperature reaches 3°C lower than the set temperature, the air conditioner starts heating again.
4Press the 
button to select the fan speed until the required setting is displayed.
Automatic (rotated : 
)
Low
Medium
High
Result: ◆ Each time you press the | button, the indoor unit beeps. |
◆The fan speed indicator increases and decreases
continuously and turns round each time you press
the 
button.
◆For the first 3~5 minutes, the fan may not operate to prevent cool air from flowing out of the indoor unit. It helps to warm the air in your room sufficiently.
Note The fan speed indicator of the indoor unit varies according to the temperature in the Automatic fan speed.
5To control the airflow direction, refer to page 19.
Control Panel
ENGLISH
