Cooling Your Room

You must select the Cool mode if you wish to adjust the:

Cooling temperature

Fan speed when cooling

1 If necessary, press the (On/Off) button.

Result: The air conditioner starts up in Cool mode with

Turbo fan speed.

The operation indicator on the indoor unit lights up. The indoor unit beeps.

IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:

Plugged in

Stopped

 

lt will start up normally after three minutes.

 

 

2 If the

is not displayed at the top of the remote control,

press the

button on the remote control one or more times until it

appears.

 

Result: The indoor unit beeps each time you press the button. The air conditioner runs in COOL mode.

Note You can change modes at any time.

3 To adjust the temperature, press the button one or more times until the required temperature is displayed.

Possible temperatures are between 18°C and 30°C inclusive.

Result: Each time you press the button:

-The temperature is adjusted by 1°C

-The indoor unit beeps

The air conditioner starts cooling, provided that the room

temperature is higher than the selected temperature.

If the room temperature reaches the set temperature, the air

conditioner stops cooling, but the fan is still operating.

4 Select the fan speed by pressing the button one or more times until the required setting is displayed:

Automatic (rotated : ) Low

Medium

High

Turbo (maximum)

Result: Each time you press the button, the indoor unit beeps.

5 To control the direction of the air flow, refer to page 15.

Note If you turn off the air conditioner in Cool mode, the set temperature is adjusted as below when you turn on the air conditioner again.

Previous set temperature

Set temperature

Over 24°C

24°C

Below 24°C

Previous set temperature

 

 

E-10