Samsung DP700A3D-A01US manual Using the WOL Wake On LAN function, Wired Network, Properties

Wired Network

Using the WOL (Wake On LAN) function

<Wake On LAN> is a function that activates the system from Sleep mode when a signal (such as a ping or magic packet command) arrives over the network (wired LAN).

1	Click Charms menu on the Desktop > Settings	>
	Control Panel > Network and Internet > Network and
	Sharing Center and click on Change adapter settings in
	the left menu pane.
2	Right-click on the Wired Ethernet Connection and select
	Properties.

3 Click Configure > Power Management tab. Select Allow this device to wake the computer, then click OK. Restart the system.

-If the system wakes up from Sleep mode even though there is no received signal, use the system after disabling the <Wake On LAN> function.

-The LAN LED may not be turned off if System is shoutdown without disabling the WOL (Wake on LAN) option.

-Connecting a wired LAN while using a wireless LAN may not activate the <Wake On LAN> function. Set the Wireless LAN to Disable to use the <Wake On LAN> function.

Chapter 3. 66

Using the computer

-<Wake On LAN> feature may not work while using Hybrid power saving feature. Hybrid sleep mode can be disabled from Power Options under Control Panel.

For Windows 7/8, Wake On LAN is not supported by Ping.

When connected to a 100Mbps/1Gbps wired LAN and the computer exits Sleep/hibernation mode, a message appears informing you of a connection to a 10Mbps/100Mbps wired LAN. This happens because when the computer exits standby/hibernate mode, restoring the network takes about 3 seconds. When the network is restored, it operates at 100Mbps/1Gbps.