Place and Connect SpeakersAV OUT
Y/C
COMP. 
Connect Antenna
Connecting the AM (MW)/LW Aerial
1.Complete assembly of the supplied AM loop antenna by rotating the base and snapping it into place.
2.Connect the two wires from the AM loop antenna to the AM ANTENNA connector on the back panel. Press down on the thumb lever to insert each wire, and then release to lock the wires in place.
Connecting the FM Aerial
Connect the supplied FM antenna to the “FM 75Ω COAXIAL” connector on the back panel. If noise or interference occurs, use an external antenna with a 75Ω coaxial cable (not supplied).
VIDEO
| AM |
VIDEO OUT |
|
CAUTION |
|
RISK OF ELECTRIC SHOCK | FM |
DO NOT OPEN |
75
Connect the supplied
AM and FM antennas
Speaker Placement
Arrange the 6 speakers as shown in your listening area.
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check the voltage.
1.Plug the main lead (marked AC Cord on the rear of the system) into an appropriate socket.
2.Press the On/Standby button to switch your DVD Player system on.
AV OUT | VIDEO | ANTENNAA | |
| Y/C |
|
|
COMP. | AM |
| |
VIDEO OUT |
|
L |
|
CAUTION |
|
RISK OF ELECTRIC SHOCK | FM |
DO NOT OPEN |
75
R
●Front Speakers : Set the front speakers so that they are aligned at ear level and at a horizontal angle of 45 degrees to the primary listening area.
●Rear Speakers : Set the surround speakers further back, parallel to the walls, at 2 to 3 feet above the ear level of the primary listening area. If the space behind the listening area is limited (i.e., close to the wall), place the rear speakers facing each other on either side.
●Center Speaker : The center speaker should be positioned with its top surface flush with the front speakers. However, you may place the speaker either on top of or next to your TV set.
●Subwoofer : Place the subwoofer at any convenient location within the vicinity of the listening area.
Speaker Connections
1.Make sure the power is turned off before connecting the speakers to prevent possible damage to the speakers.
2.Connect each red and black speaker wire to the system’s back panel as shown, being careful to connect each speaker to its correctly labeled output.
3.To insert each
Listening on headphones
Use headphones for private listening pleasure (not supplied).
Connect the headphones to the HEADPHONES jack of the front panel.
•No sound is produced from the speakers.
•To prevent hearing damage, do not raise the volume level excessively when using headphones.
Standby
Function
Open/Close
Phones
HEADPHONE jack
9 | 10 |