Setting
the Speaker Mode
Signal outputs and frequency responses from the speakers will be automatically adjusted according to your speaker configuration and whether certain speakers are used or not.
In Stop mode,
1 press MENU button.
In the Speaker
3 Setup, press the ENTER button again.
Press Cursor 
2 button to move to ‘Audio’ and then
press ENTER button.
Press Cursor 
, 
,
, 
buttons to move 4 to the desired
speaker and then press ENTER button.
•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.
•For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note |
•Depending on PRO LOGIC and STEREO, the speaker mode may vary.
47
