Samsung HTDS400RH/ELS manual Connecting the FM and AM Antennas, Cooling Fan, FM antenna connection

Connecting the FM and AM Antennas

IMPEDANCE SUBWOOFER : 4Ω

FRONT / CENTER / REAR : 4Ω

CENTER

SUBWOOFER

If AM reception is poor, connect an outdoor AM antenna(not supplied).

AM Loop Antenna (supplied)

FM Antenna (supplied)

Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.

FM antenna connection

1.Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal as a temporary mea- sure.

2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.

AM antenna connection

1. Connect the AM loop antenna supplied to the AM and terminals.

2.If reception is poor, connect an outdoor single vinyl-covered wire to the AM terminal. (Keep the AM loop antenna connected).

•If reception is poor, connect an outdoor antenna.

Before attaching a 75Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna.

Cooling Fan	The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
	normally. The cooling fan is activated automatically to supply cool air to the unit.

Please observe the following cautions for your safety.

• Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise and may damage it.

• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a newspaper or cloth, heat may build up inside the unit and fire may result.)

CONNECTIONS

17 18