Samsung HT-E355K/SH, HT-E350K/ZN, HT-E355K/HC manual Installing the Speakers on the Tallboy Stand

Installing the Speakers on the Tallboy Stand

* HT-E353K - FrontSpeakers

HT-E355K - Front/Surround Speakers

1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert three screws (5*15, For connecting Stand & Stand Base) clockwise into the three holes marked using a screwdriver as shown in the illustration.

!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 7 kg.f.cm)

1 Stand Base 2

Stand

34

Speaker

Stand

56

02 Connections

3.Straighten a supplied speaker wire and put in the hole on the centre of

Stand Base.

4. Connect the upper Speaker to the assembled Stand.

5.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

6.This is the appearance after the speaker is installed. Follow this steps to install other speaker.

Installing the Speakers on the Half Tallboy Stand

* HT-E353HK only - Front Speakers		2
1.	Stretch out the speaker cables as shown and arrange it through the 1
	hole of the stand base .
2.	When done, use the stand driver to tighten the stand nut as shown.
3.	This is the appearance after the speaker is installed. Follow these
	steps to install another speaker.

4.If you want to adjust the height of the speaker, loosen two screws on the rear of the speaker.

5.Pull up the speaker in the arrow direction. Fit the speaker in a height adjusting hole of your choice.

!CAUTION : Be careful as an excessive force may result in a physical damage.

6.Insert two screws clockwise into the hole on the rear of the speaker using a screwdriver as shown and tighten back 2 screws.

7.This is after the height of the speaker is adjusted.

You can repeat these steps above at any time if you want to readjust the height.

34

5 6

7

English 15