Installing the Speakers on the Half Tallboy Stand
02
*Front Speakers(Method 2)
1.Connect the speakers with the partition-stand as shown.
2.Insert two screws (5*15, For connecting Speakers & Partition- Stand) clockwise into the hole marked using a screwdriver as shown in the illustration.
!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm ).
12
3
Connections
3.This is the appearance after the speaker is installed.
Installing the Speakers on the Tallboy Stand
*Surround Speakers
1.Turn the Stand Base upside-down and connect it to the Stand.
2.Insert three screws (5*15, For connecting Stand & Stand Base) clockwise into the three holes marked using a screwdriver as shown in the illustration.
!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)
3.Straighten a supplied speaker wire and put in the hole on the centre of Stand Base.
4.Connect the upper Speaker to the assembled Stand.
5.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.
6.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
1 | Stand Base | 2 |
|
|
Stand
34
Speaker
Stand
56
