CONNECTIONS
DETACHING THE WALL MOUNT
1.Pull the Soundbar upwards as shown in the figure to separate it from the
wall mounts.
Detaching the Soundbar from the Wall Mounts
●●Do not hang onto the installed unit and avoid striking or dropping the unit.
●●Secure the unit firmly to the wall so that it does not fall off. If the unit falls off, it may cause an injury or damage the product.
●●When the unit is installed on a wall, please make sure that children do not pull any of the connecting cables, as it may cause it to fall.
●●For the optimal performance of a wall mount installation, install the speaker system at least 2 inches (5 cm) below the TV, if the TV is mounted on the wall.
●●For your safety, if you do not mount the unit on the wall, install it on a secure, flat surface where it is unlikely to fall.
INSTALLING THE BRACKET WITHOUT REFERRING TO THE
| 2 inches |
|
|
|
|
|
|
| 2 inches | ||
(5 cm) or more |
|
|
|
|
|
|
| (5 cm) or more | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 4.6 inches |
| 5.1 inches | |||||
|
|
|
| (11.6 cm) |
| (13 cm) |
| ||||
|
|
|
| Minimum 9.4 ~ 9.7 inches | |||||||
|
|
|
| (23.9 ~ 24.6cm) | |||||||
1.Place Wall Mount L on the desired wall surface parallel to the floor as shown above. Mark the location of the screw holes on the wall. Drill holes for the screws at the places you have marked.
2.Match the screw holes on Wall Mount L to the screw holes on the wall, and then screw one screw through the hole in its right end. Tighten the screw until it is firmly fixed to the wall.
3.Place Wall Mount R on the desired wall surface parallel to the floor and aligned with Wall Mount L as shown above. Mark the location of the screw holes on the wall. Drill holes for the screws at the places you have marked.
4.Match the screw holes on Wall Mount R to the screw holes on the wall, and then screw one screw through the hole in its right end. Tighten the screw until it is firmly fixed to the wall.
●●If you are mounting the Wall Mounts beneath the TV, make sure to position the mounts 2 or more inches(5 cm) below the TV and to align the mounts with the center of the TV as shown above.
5.Insert screws through the remaining holes, and then tighten.
12
02821G
2015/3/27 8:47:55
