DP OUT
Select the input signal to output to the next monitor and the output mode to simplify the connection and control of displaying devices.
DP OUT (MST/SST) Function Implementation
Connecting a PC via DisplayPort
――If the MST mode is selected for DP OUT, FreeSync is not supported for all connected monitors.
――Before selecting the MST mode for DP OUT, make sure that the device supports DisplayPort:MST (Daisy Chain)/HBR2 (High Bit Rate). Incorrect settings may lead to black screen or inconsistency between the actual output mode and the selected output mode. If a black screen occurs, change the DP OUT output mode.
•• MST/SST: A technology used for connection and driving of
MST
PC
DP Cable
DP IN
Monitor1
Screen A
|
| DP Cable |
| |
DP OUT | DP IN | |||
| ||||
Monitor 2
Screen B
‒‒ MST: Stands for
OSD → DisplayPort:MST
‒‒ SST: Stands for Single Stream Transport. Can transport only a combination of a single video stream and a single audio stream.
•• DP OUT mode: 5 modes
USB
USB
DisplayPort:MST
SST
PC
DP Cable
DP IN
Monitor1
Screen A
|
|
| DP Cable | |||||
|
|
| ||||||
DP OUT |
|
|
|
|
|
| DP IN | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Monitor 2
Screen A
DisplayPort:SST
HDMI:SST
OSD → DisplayPort:SST
――It is recommended to connect monitors of the same series for better compatibility and stability.
•• Make sure that the graphics card supports the MST (Daisy Chain) function. To check this, visit the website of the graphics card manufacturer.
•• The output mode of DP OUT varies with the settings of DisplayPort Ver. When DisplayPort Ver. is set to 1.1, DP OUT only supports SST.
•• When connecting a PC using DP cable, you must set DP OUT mode to "DisplayPort: MST (SST)" on the OSD menu. (OSD – System – DP OUT - DisplayPort:MST/DisplayPort:SST)
•• Because of the bandwidth limit of DisplayPort Ver. 1.2, up to four1920 x 1080 @ 60 Hz monitors can be connected and used. But this specification may vary depending on the cable used and the performance of the graphics card.
34
