![](/images/new-backgrounds/1275654/27565451x1.webp)
Tidying Up the Connected Cables
![](/images/new-backgrounds/1275654/27565451xi2.webp)
: Headphones hanger
: Downward
: Upward
1 | 2 | 3 |
4 | 5 |
Connect the corresponding cables. | Arrange the cables against the bend | Push the COVER STAND BODY REAR in |
| tendency of the cables and pull the cables | the direction as shown in the figure. |
| out of the |
|
6 | 7 | 8 |
Attach the COVER STAND BODY REAR in | Move down the COVER STAND BODY | Adjust the set height, if required. |
the direction as shown in the figure with | REAR until it covers the stand neck |
|
the buckles not being exposed. | completely. |
|
Remove the COVER STAND BODY REAR by pulling it in the direction as shown in the figure.
Place the corresponding cables into the
9
Hang the
10 | 11 | 12 |
Arrange the cables against their bend | Open the Headset Hanger by pushing it | Hang the headset. |
tendency, and then pull them through the | down. |
|
|
| |
height is changed, you need to arrange |
|
|
the cables and pull them through the |
|
|
|
|
13
Rotate and then push up the Headset | Caution | |
Hanger in the directions as shown in the | Open the | |
figure. | ||
direction as shown in the figure. | ||
|
26