Adjusting the LCD Display
→ , → [0~9]
•ID SetupAssigns distinctive IDs to the SET.
•ID InputUse to select the transmitter functions of the individual SET. Only a SET where the ID corresponds to the transmitter setting becomes activated.
•MDC ConnectionSelects a port to receive the MDC inputs from.
•Communicates with the MDC via a Serial MDC cable.
•Communicates with the MDC via an RJ 45 MDC cable.
•Network Setting•IP Setting : Manual, Auto•IP Address : Manually enter the IP Address if IP Setting is set to Manual.•Subnet Mask : Manually enter the Subnet Mask if IP Setting is set to Manual.•Gateway : Manually enter the Gateway if IP Setting is set to Manual.
MagicInfo
Available Modes
• PC
• AV
• Component
• HDMI
• MagicInfo
Note
For an EX model,
•MagicInfo can only be enabled when a network box is connected.
•The HDMI port and network box cannot be connected at the same time.
Note
•The remote control can be used to select MagicInfo. However, it is recommended to use a separate USB keyboard to utilize MagicInfo fully.
•For MagicInfo in Device mode, moving external devices while booting may cause errors. Set up external devices only if the LCD Display turns on.
92