English - 13
Viewing the Display
1. Press the INFO button on the remote control.
The TV will display the channel, the type of sound,
and the status of certain picture and sound settings.
Press the INFO button once more or wait approximately 10 seconds and it
disappears automatically.
Thedisplayidentiesthecurrentchannelandthestatusofcertainaudio-videosettings.
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to
the TV (i.e. an antenna or a cable system).
1. Press the MENU button to display the menu.
Pressthe▲or▼buttontoselect“Channel”,thenpressthe ENTER button.
2. Press the ENTER button to select “Air/Cable”.
3. Pressthe▲or▼buttontoselectthevideosignalsource,then presstheENTER
button.
4. Press the EXIT button to exit.
Air 3
Mono
Picture : Dynamic
Sound : Custom
MTS : Stereo
05 : 54 pm
Channel
Move Enter Return
Air/Cable : Air
Auto Program
Add/Delete
Fine Tune
Air/Cable
Move Enter Return
Air
Cable
Storing Channels Automatically
The TV automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
1. To select the signal source, follow the “Selecting the Video Signal-source”
instructions numbers 1 to 3.
2. Press the▲or▼buttontoselect“AutoProgram”,thenpressthe ENTER button.
3. Press the ENTER button to select “Start”.
The channel search will start and end automatically.
Press the ENTER button at any time to interrupt the memorization process
and return to the “Channel” menu.
4. After all the available channels are stored, the “Channel” menu reappears.
5. Press the EXIT button to exit.
Press the AUTO PROG. button on the remote control.
Channel
Move Enter Return
Air/Cable : Air
Auto Program
Add/Delete
Fine Tune
BN68-01184D-00Eng-0806.indd 13 2007-08-06 �� 3:31:40