Samsung LF19TRTLSH/EDC, LS19TRNLS/EDC, LS17TRTLS/EDC, LS19TRTLS/EDC, LS19TRTLSY/EDC manual

Check when	MagicTune™	* To check whether your PC is available for
MagicTune™ does	feature is found only	MagicTune™ feature, follow the steps below (When
not function	on PC (VGA) with	Windows™ is XP);
properly.	Window OS that
	supports Plug and	Control Panel → Performance and Maintenance →
	Play.	System → Hardware → Device Manager → Monitors →
		After deleting Plug and Play monitor, find 'Plug and Play
		monitor' by searching new Hardware.
		MagicTune™ is an additional software for the monitor.
		Some graphic cards may not support your monitor.
		When you have a problem with the graphic card, visit
		our website to check the compatible graphic card list
		provided.
		http://www.samsung.com/monitor/magictune
MagicTune™	Have you changed	Download the latest program. The program can be
doesn't work	your PC or video	downloaded
properly.	graphic card?	http://www.samsung.com/monitor/magictune
	Did you install the	Reboot the computer after installing the program for the
	program?	first time. If a copy of the program is already installed,
		remove it, reboot the computer, and then install the
		program again. You need to reboot the computer for it to
		operate normally after installing or removing the
		program.

Visit the MagicTune™ website and download the installation software for MagicTune™ MAC.

Check the following items if there is trouble with the monitor.

Symptom Solutions

The screen does not appear when I switch to the Client Mode.

When booting up, it takes about 30 seconds for the networking functions to be activated and no screen is displayed for about 3 to 4 seconds.

Wait 30 seconds after the power is turned on, and try to switch modes again.

If the operating system does not boot up due to damage to Windows or a blue screen is displayed, download the Windows XPe OS from this site and recover your operating system with it : http://www.syncsight.com

The client screen	1)	Check if the Hub port LED to which the LAN cable is connected blinks. If not,
appears, but I	that indicates that the LAN connection is disconnected. In this case, connect
cannot connect to	using another LAN cable.
the server.	2)	Check if the settings of the 'Settings', 'Network' tab are properly set up. The
	default setting is "DHCP". If your network uses a static IP address, select 'Use
	the following IP address' and then enter the appropriate IP address information.
	3)	Check if the 'User Name' and 'Password' set in the 'Remote Desktop' tab of
	'Settings' are the same as those of the host PC. If not, match the 'User Name'
	and 'Password' of the 'Remote Desktop' with those of the host PC.
I cannot access the	1)	Check if the Hub port LED to which the LAN cable is connected blinks. If not,
Internet in the	that indicates that the LAN connection is disconnected. In this case, connect
Client screen.	using another LAN cable.
	2)	Check if the settings of the 'Network' tab of 'Settings' have been properly set
	up. The default setting is "DHCP". If your network uses a static IP address,
	select 'Use the following IP address' and then enter the appropriate IP address
	information.

The contents (video, voice) on the server do not play smoothly on the Client Monitor.

This is because the data is transmitted over the LAN. Check your LAN connection status.

I have connected a digital device such as a digital camera, camcorder or USB

This model supports USB devices that support removable disk functions without an additional driver installation. Check if the device you want to connect to is a device that supports the removable disk function without an additional driver installation.