Samsung LS20PEJSFV/EDC manual Connecting Cables, Using the Stand, Folding the base, Model

Models: LS20PEBSFV/EDC

1 12

Page 6

Model

Connect the power cord for your monitor to the power port on the back of the monitor.

Plug the power cord for the monitor into a nearby outlet.

Use a connection appropriate to the computer you are using.

Using the D-sub (Analog) connector on the video card.

- Connect the signal cable to the 15-pin, D-sub port on the back of your monitor.

[RGB IN]

Using the DVI (Digital) connector on the video card.

- Connect the DVI Cable to the DVI IN port on the back of your Monitor.

[DVI IN]

Connected to a Macintosh.

- Connect the monitor to the Macintosh computer using the D-sub connection cable.

Turn on your computer and monitor. If your monitor displays an image, installation is completed.

Image 6

Contents

LCD MONITOR quick start guide2032GW,2232GW,2032BW,2232BW Model FeaturesPackage Contents RTA MonitorOthers Your MonitorCable Sold separatelyClick here to see an animation clip MENU buttonClick here to see an animation clip Rear Click here to see an animation clipFolding the base Connecting CablesUsing the Stand ModelYou can tilt the monitor upwards at an angle of 0 to18 Refer to the Preset Timing Modes Check ListModel Refer to the Preset Timing Modes Installation Instructionsindicator on the monitor blinking at 1 second intervals? Refer to the Preset Timing ModesIf problems repeatedly occur, contact an authorized service center Q & ACheck the following items if there is trouble with the monitor Self-Test Self-Test Feature Check Warning Messages Environment Useful TipsSelf-Test Feature Check Warning MessagesEnvironment Useful Tips