Viewing the Various Functions on Your System
You can view the various functions available on your system.1 Press the Demo button.
Result: The various functions available are listed in turn on the dis- play.
All these functions are described in detail in this booklet. For instructions on how to use them, refer to the appropriate sections.
2 To cancel this function, press Demo again.
NTSC/PAL Selection Method
According to a DISC or TV, Press the REC/Pause button on the front panel.Set the system to standby(power off) mode, press the REC/Pause button on the front panel.
Result: Each time the REC/Pause button is pressed, the following appears in the display:
NTSC 
PAL 
SECAM(option) 
Setting the Clock
GB
Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:
When you purchase the
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 | Switch the system on by pressing On/Standby. | |
2 | Press Timer/Clock twice. |
|
| Result: CLOCK is displayed. |
|
3 | Press Enter on the front panel. |
|
| Result: The hour flashes. |
|
4 |
|
|
| To... | Turn the Multi Jog knob to the... | |
| Increase the hours | Right |
| Decrease the hours | Left |
5 | When the correct hour is displayed, press Enter on the front panel. | |
| Result: The minutes flash. |
|
6 |
|
|
To... | Turn the Multi Jog knob to the... | |
| Increase the minutes | Right |
| Decrease the minutes | Left |
7 | When the correct time is displayed, press Enter on the front panel. | |
| Result: The clock starts and is displayed, even when the system is | |
in standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
You can also use 
/ 
buttons to instead Multi Jog knob in step 4,6.
2
1
3,5,74,613