Samsung MAXL45FH/UMG manual Setting the Clock, Inserting Remote Control Batteries

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:

Purchase the mini-compact system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1	Place your thumb on the position marked	on the battery com-
	partment cover (rear of the remote control) and push the cover in
	the direction of the arrow.
2	Insert two AAA, LR03 or equivalent batteries, taking care to respect
	the polarities:
	+ on the battery against + on the remote control
	– on the battery against - on the remote control
3	Replace the cover by sliding it back until it clicks into position.

Viewing the Various Functions on Your System

You can view the various functions available on your system.

1 Press the Demo button.

Result: The various functions available are listed in turn on the dis- play.

All these functions are described in detail in this booklet. For instructions on how to use them, refer to the appropriate sections.

2 To cancel this function, press Demo again.

Setting the Clock

GB

Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:

When you purchase the mini-compact system

After a power failure

After unplugging the unit

Remember to reset the time when the clock changes from winter to summer time and vice verse.

For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

1	Switch the system on by pressing On/Standby.
2	Press Timer/Clock twice.
	Result: CLOCK is displayed.
3	Press Enter.
	Result: The hour flashes.
4
	To...	Turn the Multi Jog knob to the...
	Increase the hours	Right
	Decrease the hours	Left
5	When the correct hour is displayed, press Enter.
	Result: The minutes flash.
6
	To...	Turn the Multi Jog knob to the...
	Increase the minutes	Right
	Decrease the minutes	Left
7	When the correct time is displayed, press Enter.
	Result: The clock starts and is displayed, even when the system is

in standby mode.

You can display the time, even when you are using another function, by pressing Timer/Clock once.

You can also use Program/Set button on the remote control to instead Enter button in step 3,5,7.

You can also use / buttons to instead Multi Jog knob in step 4,6.

1	4,6	4,6
		3,5,7
		4,6
	2

9