DEMO/DIMMER function
GB
All functions available on the system can be viewed on the display and the display's brightness can be switched between "on" and "off".
1 | Press the DEMO/DIMMER button. |
| Result: All functions available on the system appear on the front |
| panel display. |
| Each of these are explained in detail in this guide. Please refer to |
| the relevant section. |
2 | Press the DEMO/DIMMER button again. |
| Result: The Dimmer function is selected and the display darkens. |
3 | Press the DEMO/DIMMER button once again to brighten the front |
| panel display. |
A display brightness control can only be performed while the system power is on.
Setting the Clock
Your system is equipped with a clock which allows you to turn your system on and off automatically.
You should set the clock:
When you first purchase the
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 | Switch the system on by pressing STANDBY/ON. | |
2 | Press TIMER/CLOCK twice. |
|
| Result: CLOCK is displayed. |
|
3 | Press ENTER. |
|
| Result: The hour flashes. |
|
4 |
|
|
To... | Turn the MULTI JOG knob to the... | |
| Increase the hours | Right |
| Decrease the hours | Left |
5 | When the correct hour is displayed, press ENTER. | |
| Result: The minutes flash. |
|
6 |
|
|
To... | Turn the MULTI JOG knob to the... | |
| Increase the minutes | Right |
| Decrease the minutes | Left |
7 | When the correct time is displayed, press ENTER. | |
| Result: The clock starts and is displayed, even when the system is in | |
standby mode.
You can display the time, even when you are using another function, by pressing TIMER/CLOCK once.
You can also use 
/ 
buttons on the panel front or TUNING/ALBUM 
/ 
on the remote control to instead of MULTI JOG knob in step 4, 6.
You can also use PROGRAM/SET button on the remote con- trol instead of ENTER button in step 3,5,7.
10
