Heating Your Room
You must select the Heat mode if you wish to adjust the:
◆Heating temperature
◆Fan speed when heating
1If necessary, press the 
(On/Off) button.
Result: ◆ The operation indicator on the indoor unit lights up.
◆The air conditioner starts up in the mode selected when the unit was last used.
◆The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆Stopped
It will start up normally after three minutes.
2If the 
is not displayed at the top of the remote control, press the
button on the remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the 
button. ◆ The air conditioner runs in HEAT mode. 
Note You can change modes at any time.
3To adjust the temperature, press the 
button one or more times until the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result: ◆ Each time you press the 
button:
-The temperature is adjusted by 1°C
-The indoor unit beeps
◆The air conditioner starts heating, provided that the room temperature is lower than the desired temperature (selected temperature+3°C).
◆If the room temperature reaches the set temperature, the air conditioner stops heating, but the fan is still operating.
4 Select the fan speed by pressing the | button one or more times |
until the required setting is displayed: |
|
Automatic (rotated : | ) |
Low |
|
Medium |
|
High |
|
Result: ◆ Each time you press the | button, the indoor unit beeps. |
◆For the first 3 to 5 minutes, the fan operates very
slowly until the air has been sufficiently warmed. Once the correct temperature has been reached, the fan is automatically set to the required speed.
5To control the direction of the air flow, refer to page 19.
ENGLISH
