Samsung NV70F3553LS/EF manual NV70F35-NV66F35 SeriesEFDG68-00522FEN.indd 2013-10-08

Installation in the cabinet

With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic surfaces or adhesive from the heat.

1		545
				560
	595			572
	595		21
3	min.		min. 560
	550

min. 600

min. 50

Lower element

2	Lower	Top element
	element
Airflow through the ventilation gap
4
min. 590 -		50	min. 550
	max. 600

min. 560

Top element

There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed. For ventilation, a gap of about 50mm should be left between the lower shelf and the supporting wall. If the oven is to be installed below a hob, the hob’s installation instructions should be followed.

5

Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make sure that a gap of at least 5mm should be left between the appliance and the adjacent cabinet.

After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and release the 2 screws on the both sides of the oven.

WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.

The front exterior of the oven such as handle is different model by model. But the size of the oven in the picture is same.

English - 10

NV70F35-NV66F35 Series_EF_DG68-00522F_EN.indd 10 2013-10-08 �� 2:20:27