English - 5

Connecting to Video

1
Unplug the cable or antenna from
the back of the TV.
2
Connect the cable or antenna to the
ANT IN terminal on the back of the
VCR.
3
Connect an Antenna Cable between
the ANT OUT terminal on the VCR
and the ANT IN terminal on the TV.
4
Connect a Video Cable between the
VIDEO OUT jack on the VCR and
the AV IN 1 [Y/VIDEO] or AV IN 2
[VIDEO] jack on the TV.
5
Connect Audio cables between the
AV IN 1 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
6
Press the SOURCE button on the
remote control until you see the VCR
signal (see “To Select the Source”
on page 10).
➢
When connecting a VCR, match the color of the connection terminal to the cable.

➢ 

If you have a “mono” (non-stereo) VCR, use a Y-connector (not supplied) to hook up to the right and left audio input jacks of the
TV. If your VCR is stereo, you must connect two cables.
➢
Each VCR has a different back panel configuration.
➢
When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow).
Connecting a VCR
VCR Rear Panel
TV Side Panel
Video Cable (Not supplied)
Audio Cable
(Not supplied)
12
TV Rear Panel
Antenna Cable (Not supplied)

Connecting to S-Video

1
To begin, follow steps 1–3 in the
previous section to connect the
antenna or cable to your VCR and
your TV.
2
Connect a S-Video cable between
the [S-VIDEO] jack on the TV and
the S-VIDEO OUT jack on the VCR.
3
Connect Audio cables between the
AV IN 2 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
4
Press the SOURCE button on the
remote control until you see the VCR
signal (see “To Select the Source”
on page 10).
➢
When connecting a VCR, match the color of the connection terminal to the cable.
➢
Each VCR has a different back panel configuration
VCR Rear Panel
TV Side Panel
S-Video Cable (Not supplied)
Audio Cable (Not supplied)
12
TV Rear Panel
Antenna Cable (Not supplied)
BN68-01363D-00Eng.indd 5 2008-02-15 오후 8:09:20