Before calling service
If you have further questions or damaged accessory parts, contact us at
1. Automatic Ice Maker does not work
6. Water dispenser dripping(On some |
models) |
10. Display
•Allow your refrigerator to operate and cool down for 24 hours (1 full day) be - fore the ice maker starts producing ice.
• 
-
pacity, dispense a few cubes 8 and 16 hours after installation.
•If ICE OFF is lit, the ice maker will not make ice.
• To activate the ice maker, press the ICE OFF
12
9 | 3 |
6
<sample>
• | If the water line is not inserted into the coupler |
| properly, air could penetrate into the water line |
| causing water dripping from the water dispenser. |
• | CAUTION : Insert the water line into the coupler com - |
| pletely and slide in the clip at the end of the coupler. |
Red Clip (1/4") 
Cabinet
Tube
The display may di
er depending on models.
For details, refer to the user manual “Using the control panel.
• Recommended Temp Settings : |
2.Slow Ice cube freezing
•Check if the ice bucket is completely
inserted. (On some models)
• Freezer temp may not be enough; set it to
3.Small or bubbled ice cubes or Slow water dispensing
•
cubes may be produced.
•
4. Water filter replacement
•
clockwise so it is aligned with the printing mark on the cover, lock -
- ter printing as illustrated.
•If you are in trouble of inserting the
water supply valve. For details, refer to the “Chan -
After installation or when replacing the |
|
1 gallon (2~3minutes) of water to | PUSH |
remove trapped air from the water line. |
|
Otherwise, water may drip after dis - |
|
pensing water. (On some models) |
|
5.Water is not cool enough(On some models)
•
because the stored water in the water valve has not cooled completely. Dispense several glasses of water and then it would be cool.
Dispenser
Door Tube
1.The Water Line must be fully Inserted to the center of transparent coupler to prevent water leakage from the dispenser.
2.Insert the clip in the install pack and check that it
7.Fridge or freezer Compartments are warm
•Allow your refrigerator to operate and cool down for 24 hours (1 full day) to reach to the set temperature.
•Also, when you put room temperature or warmer food into your refrigerator, it may need an additional 24 hours for the fridge to reach the set temperature.
8.Moisture forms on outside/inside of refrigerator
•Wipe o
the condensation with a dry towel (This may occur during hot and humid seasons.)
•If the condensation occurs on the doors, turn o
the Energy Saving function.
•If you open the doors frequently or for too long, it may cause moisture inside the fridge.
9.Noise Clicks, Pops, Cracks, Snaps
•These noises may be heard occasionally inside the refrigerator. This is normal. This sound occurs when various items contract or expand while temperatures are changing; especially during defrosting. This may also occur when electronic devices including the ice maker are operating.
freezer and 37ºF(3ºC) for refrigerator. |
•
use water about 300 gallons (6 month) Reset the indi | - |
the "Ice Type/Water/Hold 3 sec for Filter Reset | " |
button for 3 seconds. |
|
•Ice 
: Press the “ Ice 
” button to turn the ice making function o
.
11.Cool Select Pantry (On some models)
•You can select your Pantry
temperature from among the following.
Wine Party Dishes (38°F[3°C]) Fresh (38°F[3°C])
Chilled (34°F[1°C]) Deli (41°F[5°C])
12.Food stored in refrigerator is frozen
•If food with too much moisture is stored near the cooling vents, it may get frozen. Be sure to keep moist food away from the cooling vents.
13.Moving and Installing
•When installing, servicing or cleaning behind the refrigerator, be sure of the following:
•
refrigerator, cut a large section of the cardboard carton and place under the refrigerator where you are working.
•Pull the unit straight out and push back in
14. Leveling & Door Alignment
•
control lever, turn it clockwise or 
Control Lever |
Flat-blade screw driver(-)
•Open the freezer drawer to gain an access to the adjustable hinge pin. Next, adjust the refrigerator door using the provided 0.16 inch wrench.
RAISE
•If you need to add more height to the door, insert the provided snap rings.
•For details, refer
to the user manual “Adjusting the level”
ENGLISH | |
|
|
1 
2012.4.2 
1:55:39 PM
